Air hammers – also called pneumatic hammers – are highly versatile tools that operate as the jack of all trades in the automotive, metalworking, and construction fields. They give you an incredible amount of optionality when it comes to freeing frozen nuts, removing welds, splitting stuck joints, or any task that requires grinding or chipping away at stubborn materials.
When it comes to difficult hammering in tight, dimly lit places, the auto hammer is king. While perhaps not the most widely known power tool, auto hammers nonetheless excel when it comes to difficult hammering tasks where a framing hammer would be too bulky to use.
If you’re wondering what the difference is between a drill with a 3/8 vs. a 1/2-inch chuck – don’t worry – you’re not alone. Unfortunately, drill manufacturers aren’t exactly clear when it comes to this topic, which can get a little confusing.
When it comes to tool brands, there are many options out there – which is why narrowing it down to just one can be tricky. Comparing DeWalt vs Metabo HPT is tough as both are highly regarded tool brands, with DeWalt being the better-known among North American consumers.
When it comes to tool brands, two of the best options out there are Japanese tool manufacturers Makita and Ryobi. Keep in mind that both brands compete in slightly different market segments, but there is some overlap when comparing Ryobi vs Makita.
When it comes to the ideal size screw to use for a 2×4, there’s a lot to consider. 2x4s – like any other lumber type – can be attached in several different ways such as face-to-face, toenailing, or attaching to end grain.
This debate pops up all the time in online forums and among DIYers, and due to Kobalt’s low prices is not all that surprising. Whether or not Kobalt is actually a good tool brand is the subject of some debate, so let’s take a closer look at this tool brand.
If you’re a DIYer, then you’re bound to run into a situation where you need to tighten a bolt without a wrench. It can happen when you need to tighten a loose table leg, are repairing a bike, or need to fix a leaky kitchen sink.
Nuts and bolts are some of the most common fastener types used in all sorts of mechanical applications. They’re used to hold two or more objects together, with the nut on one end and the bolt on the other, and the fastened material sandwiched in between.
Bandsaw’s typically come from the factory with a stock fence, but oftentimes this fence is lacking in quality. Upgrading to an aftermarket fence will greatly increase the functionality of your bandsaw by allowing you to make perfect resaw cuts, precise joinery, and create smooth curves.